Engine Repair in Irving, TX
NexGen Auto handles engine repair in Irving, TX — misfires, oil leaks, overheating, timing components, gaskets, and diagnostic-first engine work for cars and trucks.
What we hear from drivers.
- Rough idle, misfire, or hesitation
- Visible oil leak or low oil between changes
- Coolant loss or overheating
- Loss of power or fuel economy
- Knocking, ticking, or rattling under the hood
What you get.
- Diagnostic to confirm cause before any disassembly
- Gasket and seal replacement (valve cover, oil pan, timing cover)
- Coil, plug, and ignition-system service
- Timing-component service where applicable
- Cooling-system repair tied to engine performance
Diagnose first. Then repair.
- 01
Diagnose
Live data, pressure tests, and physical inspection — not guesswork.
- 02
Quote
Written scope before parts are ordered or anything is opened.
- 03
Repair
Replace what's needed with OEM-grade parts as the default.
- 04
Verify
Drive cycle and re-scan to confirm the fix held.
Local shop. Honest answers.
NexGen Auto is based at 1540 E 6th St in Irving, TX — easy reach from Las Colinas, Valley Ranch, Coppell, Grand Prairie, and the DFW Airport area. We service cars, trucks, and SUVs, and we work on daily drivers, lifted trucks, and Jeeps.
Every job starts with a written estimate. Parts are OEM-grade by default; we'll show you the budget option when one makes sense and let you decide. Nothing leaves the bay without a short road test to confirm the repair held.
Things that often come together.
Common questions.
Should I rebuild or replace my engine?
Depends on the failure mode, vehicle value, and parts availability. We pull data first — compression, oil analysis, scope inspection — then talk through options with cost ranges for both paths.
Why does my car burn oil?
Usually worn valve seals, piston rings, or a PCV-system issue. We test compression and leak-down to figure out which and how bad before recommending work.
Is overheating an emergency?
Yes. Stop driving as soon as it's safe — sustained overheating warps heads and destroys gaskets. We'll diagnose the cause (thermostat, water pump, head gasket, radiator) before the damage compounds.
Can you do engine work on European cars?
Many European platforms, yes. Some require dealer-only software or specialty tools — we'll tell you honestly during diagnosis if your specific car is better off at the dealer.
Drop by. Or call ahead.
- Address
- 1540 E 6th St
Irving, TX 75060 - Hours
- Mon – Sat8 AM – 7 PMSunday10 AM – 5 PM
